Reply to thread

Message

My install in my Target helmet.

I used pin post screws with the screw part epoxied to the helmet, modified picture hangers, and nuts to hold everything together. I got to find some 8/32 thumb nuts to fit the screws instead of the nuts as it will make visor removal much easier.

No glue, no fuss no muss easy visor removal.
[ATTACH=full]86974[/ATTACH]
[ATTACH=full]86975[/ATTACH]
[ATTACH=full]86976[/ATTACH]
[ATTACH=full]86977[/ATTACH]

My old MSH was similar.
[ATTACH=full]86978[/ATTACH]
Lynn

[QUOTE="Lynn TXP 0369, post: 141929, member: 21"] My install in my Target helmet. I used pin post screws with the screw part epoxied to the helmet, modified picture hangers, and nuts to hold everything together. I got to find some 8/32 thumb nuts to fit the screws instead of the nuts as it will make visor removal much easier. No glue, no fuss no muss easy visor removal. [ATTACH=full]86974[/ATTACH] [ATTACH=full]86975[/ATTACH] [ATTACH=full]86976[/ATTACH] [ATTACH=full]86977[/ATTACH] My old MSH was similar. [ATTACH=full]86978[/ATTACH] Lynn [/QUOTE]

This thread is more than 2 months old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification