Reply to thread

are you epoxying the female portion onto the inner portion of the helm?

i made mine pepakua style so i have a ledge just inside that goes all the way to the face of the helm. its not flush to the inner portion of the visor like yours is


This thread is more than 2 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top