Reply to thread

Anyone had their T-Visor crack? I was drilling the holes into the visor so I can use the bolt method and it cracked in half. The bit is new and sharp, and I didn't put any pressure on it at all. It's a nice visor, but seems very brittle.


This thread is more than 57 days old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top