This isn't a Mando bucket, but I found this thread while I was looking for a way to install the visor in my Phase II Episode III bucket and thought I would adapt it a little for that.
Dark green visor with some visor templates taped on. My wife made these by eye and did a pretty good job keeping the template symmetrical.
[ATTACH=full]86950[/ATTACH]
[ATTACH=full]86951[/ATTACH]
Then Thorn puts his beer goggles (visor) on ... I made a cardboard visor template to help with the placement of the chicago screws on the inside of the helmet.
I put the screws in the cardboard template and dabbed a little paint on the backside of the screws to mark the inside of the helmet. Then I used my dremel to scuff up the inside of the helmet in preparation for epoxy putty.
[ATTACH=full]86952[/ATTACH]
[ATTACH=full]86953[/ATTACH]
[ATTACH=full]86954[/ATTACH]
After this, I applied the 5 minute epoxy putty directly to the chicago screws and pressed them and the cardboard template onto the inner surface of the helmet.
[ATTACH=full]86955[/ATTACH]
[ATTACH=full]86956[/ATTACH]
Boom, baby! Visor installed. I left the protective film on the plastic for now because I plan to have it in and out a few more times while I do some more painting.
[ATTACH=full]86957[/ATTACH]
