Reply to thread

a good way to hold the cardboard mock up in place while you line things up is to use some of that wall putty that 3M puts out for putting posters on walls without leaving marks.  also, if you end up using epoxy putty to place your visor, the putty will help with the best areas to apply that as well


This thread is more than 2 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top