Reply to thread

Well, I am having troubles with this.  I bought my T-VIsor from en eBay seller that carries tons of these, and now that I have it I realize that the vertical portion of the 'T' is exactly as wide as the opening on the mask.  This leaves no room for attaching it properly.    I can't even hot-glue it in there, let alone bolt it.


Ideas?!


This thread is more than 2 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top