Reply to thread

Thank you MinaFett and Spicy Fett. You two have been more help to me with your comments here alone than the mandalorian mercs forum. I wouldn't risk doing this on the Jango helmet (yet then again, it already came with the key slots/vent installed in the back) I tried using E6000 rubber cement yet I'm not getting the full results I want. I researched around and epoxy putty seems to be the best idea that I can gather. Would you agree? Thanks again


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top