Reply to thread

All the parts were drawn out and designed by me using the reference pictures, so no found parts except for the foam lining which was found at Target :D.


I routed out most of the parts using a computer aided router from my drawings. 

The two large eyepieces were made by hand by cutting different thicknesses of styrene, and I sculpted the nub greeblies using sculpey.

Sizing the pieces was a trial and error deal until I finally got the proper looking sizes.

I then molded all the parts so I can make future builds.


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top