Reply to thread

It was probably for some kind of casting.  To my knowledge, you don't need to spray or coat the mould with anything, since the plastic doesn't get hot enough to melt to the mold.


Be sure to post progress pics, I'd really like to see how it turns out!


This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top