Reply to thread

Be sure to check out the vacuum forming forum on the discussion board at tk560.com.  Several of us have built large or small over-and-under machines, and there are threads about them (and other designs besides flip-over machines, too).


By the way, I'd be interested to hear how Gingery's adjustable frames work.


Paul


This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top