Reply to thread

Message

Just curious..most of those sites talk about the type of machine that actually folds over. I am going to build the type that drops down. I purchased the book "A Plastic Vacuum Forming Machine" by Vincent Gingery. It has some good information if you want to build the drop down type. I think I paid about $15 for it. I am planning on making it large enough to make the chest piece and the helmet (eventually as I am talent limited!!). Good luck in your progress.

Jdboushh

[QUOTE="jdboushh, post: 104988, member: 1497"] Just curious..most of those sites talk about the type of machine that actually folds over. I am going to build the type that drops down. I purchased the book "A Plastic Vacuum Forming Machine" by Vincent Gingery. It has some good information if you want to build the drop down type. I think I paid about $15 for it. I am planning on making it large enough to make the chest piece and the helmet (eventually as I am talent limited!!). Good luck in your progress. Jdboushh [/QUOTE]

This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification