Reply to thread

Hi I am a profesional vacuum former and we use a special 2 part resin material to produce production molds . It is specialy formulated to withstand the heat and stresses put on them . Its about $80 for 1.5 gallons of volume and is sold by the pound . It can be machined carved sanded or filled to shape and lasts about forever.


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top