Reply to thread

You both, seem very knowledgable on the subject. Do you coat the positive with anything before forming, Not like a release agent but more like a durability coat or is the material that you spoke off usual durable enough to hold up?


Doesn't the clay you used to patch the form smash on you when you form it  or isn't there enough pressure?


Thanx. Man this forum is great


ZeroVis


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top