Reply to thread

Cheers for the reply STG using oven and a cyclone house vac (quite strong suction) iv just pulled a piece of fett armour off a mold and wasnt too impressed i mean it looks good but there was no major vacuum effect i ended up pushing most of it down *dont think i baked plastic long enough though bud will try again tomorrow as its 2 am now lol and i only stopped with the jigsaw half hour ago lol* will try and post a pick tomorow (be advised lots of tape round edges of box run outta wood fill lol)


This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top