Reply to thread

The flat parts are bent along the dotted lines and will have the shape presented on the right and bottom parts. The small ears from the right flat piece goes into the holes on the left piece. After you do all the strap webbing, the shear pressure and friction applied by the buckle will hold the belt in place:



This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top