Reply to thread

Message

I got a U.S. Divers belt buckle from eBay recently. I got mine for $40, but I've seen them go for upwards of $75.

If anyone's interested in trying to make their own buckle out of something like aluminum, here's a blueprint. You'd probably want to use 16 or 20 gauge material.

The dotted lines indicate a bend, except the lateral dotted line on the buckle base, which indicates an optional rolled groove (that my buckle has). I'll try to find a picture of that.

The PDF template is intended to be printed at 100%. Enjoy!

[ATTACH=full]8429[/ATTACH]

[QUOTE="Rich D, post: 120730, member: 1047"] I got a U.S. Divers belt buckle from eBay recently. I got mine for $40, but I've seen them go for upwards of $75. If anyone's interested in trying to make their own buckle out of something like aluminum, here's a blueprint. You'd probably want to use 16 or 20 gauge material. The dotted lines indicate a bend, except the lateral dotted line on the buckle base, which indicates an optional rolled groove (that my buckle has). I'll try to find a picture of that. The PDF template is intended to be printed at 100%. Enjoy! [ATTACH=full]8429[/ATTACH] [/QUOTE]

This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification