Reply to thread

Message

Yes, 9 was too much. but a large percent of it was on the helmet dome.

My last mold turned out pretty good, but the dome rippled when i was casting it.

So I did about 4-6 full coats, with an extra 3-4 on dome, and re-inforcing the cheeks/mandibles and the key holes.

I going to pour a clay solid of it tonight, and start my sculpting, cutting etc.

As far as I can tell, the overcoat sealed/solidified it enough. I only plan do do maybe 5 runs on this mold, and it was a test mostly.

Ill pull a resin of it before I fill it wlith liquid clay and pos *** to see if it worked out well.

[QUOTE="Stormrider, post: 186218, member: 2155"] Yes, 9 was too much. but a large percent of it was on the helmet dome. My last mold turned out pretty good, but the dome rippled when i was casting it. So I did about 4-6 full coats, with an extra 3-4 on dome, and re-inforcing the cheeks/mandibles and the key holes. I going to pour a clay solid of it tonight, and start my sculpting, cutting etc. As far as I can tell, the overcoat sealed/solidified it enough. I only plan do do maybe 5 runs on this mold, and it was a test mostly. Ill pull a resin of it before I fill it wlith liquid clay and pos *** to see if it worked out well. [/QUOTE]

This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification