Reply to thread

Message

5% worked great, thank you. You just saved me a tonne of time trying to figure it out for myself.

As with Braveheart93 above me, I'm a bit confused with the codpiece. I'm assuming the cod piece centre plate is the part that descends vertically and the cod piece left, right and centre is the part that folds off at an angle, which leaves a gap to be filled. Do I line that with bondo? I have experience using car filler to remove imperfections and strengthen things but I've never used it as a bridge between two points before.

[QUOTE="Jesuit24, post: 53068, member: 6777"] 5% worked great, thank you. You just saved me a tonne of time trying to figure it out for myself. As with Braveheart93 above me, I'm a bit confused with the codpiece. I'm assuming the cod piece centre plate is the part that descends vertically and the cod piece left, right and centre is the part that folds off at an angle, which leaves a gap to be filled. Do I line that with bondo? I have experience using car filler to remove imperfections and strengthen things but I've never used it as a bridge between two points before. [/QUOTE]

This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification