Reply to thread

It looks like the small splits occurred where I had to switch from the clear resin to the grey resin. I miscalculated how much the print was going to use and didn't have any more clear.

Sorry.

The build is looking really good!


This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top