Reply to thread

Alright team,


So I was unhappy with the red for the mandibles. Mixing paint, I'm finding out, is very difficult. It's very hard for me to tell if it's the tone I'm looking for until it is on the helmet, dry, and right next to the rest of the colors on the lid. Anyways I'm much much happier with my second attempt on the red.


[ATTACH]56718[/ATTACH]


I was also able to knock out the majority of the fine detailing topical work today!


[ATTACH]56719[/ATTACH]  [ATTACH]56720[/ATTACH]  [ATTACH]56721[/ATTACH]



 [ATTACH]56722[/ATTACH]  [ATTACH]56723[/ATTACH]  [ATTACH]56724[/ATTACH]


You can see on the cat scratch where the paint peeled up from the masking fluid. I'm going to paint a few more layers in the gap until it is flush. Then hopefully use steel wool to hide the blemish.


[ATTACH]56725[/ATTACH]  [ATTACH]56726[/ATTACH]  [ATTACH]56727[/ATTACH]


[ATTACH=full]56718[/ATTACH]


[ATTACH=full]56719[/ATTACH]


[ATTACH=full]56720[/ATTACH]


[ATTACH=full]56721[/ATTACH]


[ATTACH=full]56722[/ATTACH]


[ATTACH=full]56723[/ATTACH]


[ATTACH=full]56724[/ATTACH]


[ATTACH=full]56725[/ATTACH]


[ATTACH=full]56726[/ATTACH]


[ATTACH=full]56727[/ATTACH]


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top