Reply to thread

Finished my table and want to do some Vac pulls of armor and a mask. What would be the best type material and thickness? Easiest to find and cheapest. Dont really care about quality at this point just want to give it a test run and see how it pulls.


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top