Reply to thread

Hey guys,

I work in Telecom and during a purge of some phone equipment (was recycling some Mitel 5330e IP phones) I thought I might try to see if I could extract the speakers from the speakerphones, and I was able to (See pic below). Has anyone custom wired a couple speakers to the TRamp box (Unless there is an optional "Output" on the box) and then to their costumes for further amplification? Or do those of you who have the TRamp box feel like the quality of the volume is good enough. Not being an "Audio Guy" here is what I know about those speakers I pulled out of those Mitel phones.


Manufacturer: Stetron

Model: P0050025

Size: 50mm

Height: 23.5mm

Impedance: 25Ω

Power: 0.5w/1.0w

Fo: 270Hz

SPL: 89dB


[ATTACH=full]185462[/ATTACH]


What are you guys' thought? Think it may be something to look into?


Thanks,

-Iron


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top