Reply to thread

Thingiverse or my mini factory are good sources for 3d files.

If you have a printer then the rest you can figure out depending on your model.

If you don't try 3dhubs for people that can print for a fee in your area.


Sent from my SM-G935F


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top