Reply to thread

I've re- made my molds ... again :facepalm  I cleaned up the first casting to get a nice second mold.  I then poured a new master in liquid plastic but on one of them, I must not have put enough mold release and well, I destroyed the mold.  Now I've gotta wait til I get more rubber. :(


I might try throwing the plastic casting on the vac table and see how they vaccuum form.  I'm not sure if I like that plastic though.


Yvonne, what brand of liquid plastic are you using these days?


....hey, I'm trying to make some more progress :D  ... yay!


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top