Reply to thread

Message

Well, the little projects continue, but the good news is the thinner finally arrived so now I may carry on with the bucket, but probably not until tomorrow.
So in the meantime I turned my attention to the collar studs. These should not take too long at all. A few strokes of humbrol 60 on the one going on the far right of the collar, and a coating of humbrol 108 on the one going on the far left.

[ATTACH=full]142809[/ATTACH]

And done.

[ATTACH=full]142810[/ATTACH]

[QUOTE="tjr2d2, post: 418037, member: 6803"] Well, the little projects continue, but the good news is the thinner finally arrived so now I may carry on with the bucket, but probably not until tomorrow. So in the meantime I turned my attention to the collar studs. These should not take too long at all. A few strokes of humbrol 60 on the one going on the far right of the collar, and a coating of humbrol 108 on the one going on the far left. [ATTACH=full]142809[/ATTACH] And done. [ATTACH=full]142810[/ATTACH] [/QUOTE]

This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification