Reply to thread

Not the magazine, haha. (if anyone remembers that magazine)


I've run into a fitment issue with my helmet, so along the way I'll post up my work arounds on how I am resolving my issues. My cheek plates hit my cheek bones so I had upscaled the entire helmet by 3%. So far it's ok, but I might shallow out the cheek plate section.


Anyone have any tips or tricks they have used, post 'em up.


This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top