Reply to thread

Yeh heat gun on styrene can be very brutal. Even a hair dryer may work but unless you know what your doing and how long to heat the styrene for, I wouldnt recommend heating it. None the less v2.0 will eliminate that, wasnt pleased with the curve of the 1st edition so will be trying to fix that issue.


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top