Reply to thread

Having fresh eye on a hunt is always welcome:)





well there are some folks who are in what i am calling camp 3 "Those who believe the part was machined (created from stock)" who feel that way.


Camp 1, people who believe this dental piece was an unaltered known part, easy to place / install on the helmet. what was easiest to do for the builders

Camp 2, people who believe more likely that the builders altered a known part, nothing to complicated vise down, drill one hole - done.

Camp 3, Those who believe the part was machined (created from stock). too hard time consuming, imo


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top