Reply to thread

All foam is NOT created equal.


Polyurethane foam can be vac'd over.  I do this all the time.  6# density is fine for this.  4# is OK if there is no sharp corners or detail.


Do not confuse with EPS (expanded polystyrene) which will crush  melt, and fuse to plastic.


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top