Reply to thread

UPDATE: Sample of digital magic. If I could get them cast in chromed steel they might look like this... (Unfortunately they would be far too expensive this way.)


[ATTACH=full]127628[/ATTACH]


Still, it looks rather pretty and this is a good exampe of the new "shape" as this is what the 3D printer will use. It's extremely high poly count.


This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top