Reply to thread

Message

Update: 2 steps forward, 1 step back.

Due to some sizing factors with the modeling, having to re-size the detonator body design digitally. In short this means I have to scrap about 60% of my work and start over with some parts. I should see some activity this weekend and with luck, ready to get it prototyped by Sunday. Once we have a prototype to be sure I scaled things properly, we'll be setting up the Kickstarter video, then figuring out costs and then assigning rewards. I suspect it's about a week to a week + a half out before we can launch but that is also dependent on the time it takes to prototype. Because we're going to have to get some material samples (not free samples...) and that takes money aaaand our pre-launch budget is continually being devoured by progress, I'm going to do another short-run of cold-cast detonators starting tomorrow, so if you want to get your hands on one, I'll post a link here by morning. (8/17/12)

Thanks!
-Rachel

<blockquote data-quote="xeco" data-source="post: 348415" data-attributes="member: 1384">Update: 2 steps forward, 1 step back.Due to some sizing factors with the modeling, having to re-size the detonator body design digitally. In short this means I have to scrap about 60% of my work and start over with some parts. I should see some activity this weekend and with luck, ready to get it prototyped by Sunday. Once we have a prototype to be sure I scaled things properly, we&#039;ll be setting up the Kickstarter video, then figuring out costs and then assigning rewards. I suspect it&#039;s about a week to a week + a half out before we can launch but that is also dependent on the time it takes to prototype. Because we&#039;re going to have to get some material samples (not free samples...) and that takes money aaaand our pre-launch budget is continually being devoured by progress, I&#039;m going to do another short-run of cold-cast detonators starting tomorrow, so if you want to get your hands on one, I&#039;ll post a link here by morning. (8/17/12)Thanks!-Rachel</blockquote>

[QUOTE="xeco, post: 348415, member: 1384"] Update: 2 steps forward, 1 step back. Due to some sizing factors with the modeling, having to re-size the detonator body design digitally. In short this means I have to scrap about 60% of my work and start over with some parts. I should see some activity this weekend and with luck, ready to get it prototyped by Sunday. Once we have a prototype to be sure I scaled things properly, we'll be setting up the Kickstarter video, then figuring out costs and then assigning rewards. I suspect it's about a week to a week + a half out before we can launch but that is also dependent on the time it takes to prototype. Because we're going to have to get some material samples (not free samples...) and that takes money aaaand our pre-launch budget is continually being devoured by progress, I'm going to do another short-run of cold-cast detonators starting tomorrow, so if you want to get your hands on one, I'll post a link here by morning. (8/17/12) Thanks! -Rachel [/QUOTE]

This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification