Reply to thread

Ever tried the Onyx resin before? I've grown to be a big fan of it, really great properties for slushing and the fast cure version shaves a lot of cure time off for much faster production. Higher melting temp makes it much more warp resistant too. And if you choose to offer cold-casts of these the black naturally helps that too. Only problem is it's hardness can make it brittle when thin, but looks like you're casting these very thickly.


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top