Reply to thread

The helmet is powered by small aa batteries that are in a harness attached by a 9v connector. The card (built on a breadboard about 2 inches wide) controls the timing of the LEDs no servos in this baby.  The power switch appears in some of the ref cd's not sure if the card appears though. Yeah I would be curious to know about the grooves the only ones I knew about were the three Art pointed out above (Are there more?)


All the Best


Lee


This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top