Reply to thread

Message

Very interesting. I don't think I have that then on my Bobamaker V3 helmet then. Thank goodness. I was looking at some of the CRLs and other people's helmets and it looks like it's relatively common for it to be close at the top of the T visor and to get a little bigger towards the bottom of the helmet. I don't know the mandible gap dimensions from the OG helmet and couldn't find a thread about it, so it's hard to say what's most accurate.

Either way my helmet now sits in the closet on a gigantic roll of Bounty paper towels.

[QUOTE="joe, post: 498647, member: 11382"] Very interesting. I don't think I have that then on my Bobamaker V3 helmet then. Thank goodness. I was looking at some of the CRLs and other people's helmets and it looks like it's relatively common for it to be close at the top of the T visor and to get a little bigger towards the bottom of the helmet. I don't know the mandible gap dimensions from the OG helmet and couldn't find a thread about it, so it's hard to say what's most accurate. Either way my helmet now sits in the closet on a gigantic roll of Bounty paper towels. [/QUOTE]

This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification