Reply to thread

Message

I’ve searched quite a bit and I can’t seem to find any answers regarding some specifics on Zam's Mabari cape seal.

Basically, I’d love to know:
1.    What the outside dimensions are.
2.    Its approximate thickness.
3.    And if anyone has any idea what the back should look like (what kind of fastener or fasteners).

I’m interested in trying a scratchbuild of the piece out of metal. I have the Visual Dictionary (the image looks a bit skewed to me) and I found a couple of shots from the FIDM exhibition. I could probably extrapolate dimensions that are close. However, I’d like to be as accurate as possible.

Can anyone point me in the direction of any specific information or additional reference photos?

<blockquote data-quote="Entropy" data-source="post: 115211" data-attributes="member: 1848">I’ve searched quite a bit and I can’t seem to find any answers regarding some specifics on Zam&#039;s Mabari cape seal.&nbsp; &nbsp;Basically, I’d love to know:1.&nbsp; &nbsp; &nbsp;&nbsp; What the outside dimensions are.2.&nbsp; &nbsp; &nbsp;&nbsp; Its approximate thickness.3.&nbsp; &nbsp; &nbsp;&nbsp; And if anyone has any idea what the back should look like (what kind of fastener or fasteners).&nbsp;I’m interested in trying a scratchbuild of the piece out of metal.&nbsp; I have the Visual Dictionary (the image looks a bit skewed to me) and I found a couple of shots from the FIDM exhibition.&nbsp; I could probably extrapolate dimensions that are close.&nbsp; However, I’d like to be as accurate as possible.&nbsp; &nbsp;Can anyone point me in the direction of any specific information or additional reference photos?</blockquote>

[QUOTE="Entropy, post: 115211, member: 1848"] I’ve searched quite a bit and I can’t seem to find any answers regarding some specifics on Zam's Mabari cape seal. Basically, I’d love to know: 1. What the outside dimensions are. 2. Its approximate thickness. 3. And if anyone has any idea what the back should look like (what kind of fastener or fasteners). I’m interested in trying a scratchbuild of the piece out of metal. I have the Visual Dictionary (the image looks a bit skewed to me) and I found a couple of shots from the FIDM exhibition. I could probably extrapolate dimensions that are close. However, I’d like to be as accurate as possible. Can anyone point me in the direction of any specific information or additional reference photos? [/QUOTE]

This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification