Reply to thread

Update!

I never got my parts from from Fiernock Base Designs... So that money is gone.


I have finally decided to buy a 3D Printer to try and finish this build.

Thank you MinuteFett for the sale on 3 files for helmets. I did a test print and still learning the software. Failed my first "BIG" print. But made some successful smaller prints and slowly working my way up. I think I know where I went wrong.


Thank you [USER=13269]Mtpapa121[/USER] for the link. I will definitly begin this soon.


Here is my first failed attempt to print the Din Djarin bucket


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top