Reply to thread

Thanks for the comments, i feel I'm making some progress now!

I decided the left lower cheek was slightly out, so off it came and was replaced with a slightly revised shape, this also enabled me to add the curved profile on the bottom edge i had missed. The dome has been fitted and the join profile added. Also adding the final upper right ear platform...


[ATTACH=full]38025[/ATTACH]


[ATTACH=full]38026[/ATTACH]


[ATTACH=full]38027[/ATTACH]


[ATTACH=full]38028[/ATTACH]


This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top