Reply to thread

I think another element to this method is to ensure that the Visor DOESN'T apply any stress to the TeeNut/ or mandibles....

You don't want your Visor, once installed, to be the piece that holds your mandibles in place...causes way too much stress that way.


**That's why it is imperative that you make a Visor template prior to installing the TeeNut's or making holes in your visor.:thumbsup:


This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top