Reply to thread

Good way might be to measure a segment, such as the length of one of the back panels, or the height of an ear. And scale the stencils to that known measurement. Get enough such measurements as data points and you should be able to make a pretty good averaged size ratio.


Otherwise, just sorta keep trial and erroring it till they start fittin. And better a little too small than too big.


This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top