Reply to thread

Well I got enough money to make the mold I soon as I sell some of my bust I'll buy some silicone.

Heres what I did so far: I found out that if you mix bondo with polyester resin(add both hardeners)

 

 

 

[ATTACH]21598[/ATTACH]

it makes a great gelcoat when it comes to making a mold for silicone mask, so I did that poured it on.

Once it cured I mixed an epoxy resin thats about 12 hours to cure, added some fiber-glass mat(about 1:1 ratio of fiber-glass and resin) applied it,

 

 

[ATTACH]21599[/ATTACH]

once I did that a few times I started on the other side and should do the second coat tomorrow.

[ATTACH]21600[/ATTACH]


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top