Reply to thread

I like to give the ear base colors at least 24 hours to cure before I tape them off for the markings, so I'm working on a couple of the accessories.

Here are the RF (pre-assembled by RS Props) and the Elstree Precision Borden piece.

I still need to add the rust stains on the RF stalk.


[ATTACH]217520[/ATTACH] [ATTACH]217521[/ATTACH]


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top