Reply to thread

Thanks, all!  I received the visor a while back, but I was working on a commission so

I put this helmet on the back burner.  I finally had a chance to install it, so here are

some finished pics!


[ATTACH=full]133469[/ATTACH]


I went with a standard shade 3 welding visor for this project.


[ATTACH=full]133470[/ATTACH]


Here are a couple of angles of the back.


[ATTACH=full]133471[/ATTACH]


[ATTACH=full]133472[/ATTACH]


Two closer shots to show some of the multi-layer weathering.


[ATTACH=full]133473[/ATTACH]


[ATTACH=full]133474[/ATTACH]


This was a really interesting side project.  I'm a big fan of the concept artwork from the OT

and I had a lot of fun bringing one of those concept sketches into the 3D world.  :)


This helmet doesn't really fit in with the rest of my collection though, and I'm going to offer

it up to a good home in the Cargo Hold.  If you're interested, look for the FS post.  :thumbsup:


Thanks to everyone who followed along with the build!


This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top