Reply to thread

I use enough epoxy so that the screw heads are completely coated, but

I don't necessarily get it so it's level with the surface. 


I have had the epoxy dry so that it comes slightly above the surface (not on

purpose) and it's generally not a problem because the holes in the sides of the

helmet are a little larger.


This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top