Reply to thread

Got the basic shapes done on the rear panels.

Everything was stenciled and masked using Winsor and Newton masking fluid.

Next I'll be going in with a fine brush to refine the shapes and add the smaller details.


[ATTACH]191493[/ATTACH] [ATTACH]191494[/ATTACH] [ATTACH]191495[/ATTACH] [ATTACH]191496[/ATTACH] [ATTACH]191497[/ATTACH]


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top