Reply to thread

Having just had a fibreglass cast removed I dont see why FBG Cast wraping wouldn't work, mind you it had to be moist to go on so i dare say you would to A: do it really fast and be do it in strips & sections. I'm not to sure of the costs either, but the stuff does dry hard raipdly and is quite malleable until it hardens. I assume that it's textured surface would also be a reasonable base on which to adhere your exploxy coats onto.


This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top