Reply to thread

Eric, Thank you for pointing out the other requirements needed for the stencils, Again, I did not realize, what was needed as I have never

painted a helmet.  I was basically thinking about the layers in the back of the helmet eg : main general areas, I tried to use the provided stencils

and tried tracing it and what was traced was not the same as the stencil itself, so, I scrapped the project. Lol.


This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top