Reply to thread

Hi! I've been looking at this forum for a while now, but I'm new to process of making a helmet and not really familiar with any of the real technical terms involved. I just got my first resin cast from ebay and there is a hard white thing inside the gray resin cast. I haven't seen this in any other user's first helmets and was wondering if I am supposed to remove this and if so how I should?

Beyond this, the forum has been a tremendous help on how to make this and I can't wait to start into this process!


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top