Reply to thread

All's you need is pep designer, and that's free. To save the models, yes you need the passcode but if you email me the blend. file, I can take care of it. In blender, select your model, go to the top left, export, wavefront obj. and select destination. Then go there, right click on it, and click open with... and select pep designer. there ya go.


This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top