Reply to thread

I thought that somewhere, someone had already thought of my "bright idea" of a spiked crest. Mine was going to be more like a half crest I suppose, so it would be a little different. I wanted the spikes to start higher up the brow of the helmet though.

 

 I haven't found a suitable deer rack to cut the points off of to make spikes out of them yet. I'll have to crawl up above my garage to dig for them tomorrow and see what I've got stashed up there.


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top