Reply to thread

On the styrofoam balls.. cote them in Elmers Glue All white Glue.. it will coat the styrofoam so they can be painted. better yet after coating them.. you can smooth them out using Elmers Wood putty.. its water soluable and easy to use.. dont buy the tub as it just dries out.. get the tube... ..if its dry and if you want it smoother before sanding you can wet sand it.. or while putting it on.. you can wet your finger to smooth it out...


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top